Rear Engine Door Installation !!!!!

A.C.P weighted down with objects

Well as you are aware, we had fabricated the frame work whilst awaiting the adhesive on the rear apron to set. So I don't have any pictures of this part even though it is basically a square frame and is measured to fit the rear recess that accesses the engine bay. I did how ever welded in some supports where the two locking handles were to be fitted, these locking handles and the gas struts were purchased through eBay and at a good price, the piano hinge was sourced through the local hardware store. Once I had the main frame welded up and checked for square (very important) I then did some prep work on the welds, like grinding them flat where the A.C.P was to be secured, again I use sikaflex to secure it down and used objects to apply even weight all over the

Rust Removal !!!

Rusted section, whole underside is hollow !!

Another couple of hours on our project doing some more rust removal. We had already pre-fabricated the 50x50 shs to replace the rusted section o

Motorhome rear section taking place !!!!

Preparing to cut out some more rust

Well the whole Family has been abit crook this week, but i still managed to slip in a few of hours in this week end to work on the motorhome. It's quite amazing how much you can get done in only

Some new framing in

Day out @ the Caravan and camping show

Well, We headed off at about 10:30 am to visit the Caravan and camping show at the Claremont Show grounds, we battled the hectic Perth roads,